Forming · LPG cylinder production line
Decoiling, levelling and feeding run in a closed servo loop, holding blank length within ±0.2 mm without manual correction before drawing.
End-dish dies for 1 kg to 50 kg cylinders change in about 30 minutes, so a single line covers the full product range.
Offcuts are collected on a conveyor instead of accumulating beside the machine, keeping the aisle and the operator station clear.
Standard machine data below. Non-standard sizes can be tooled to your cylinder drawings.
| Plate thickness | 2–4 mm |
|---|---|
| Plate width | ≤1250 mm |
| Coil inner/outer Ø | Φ(450–800) mm ≤ Φ1600 mm |
| Coil weight | ≤15 T |
| Stamping cycle | 2 pcs / 14 s |
| Stamping size | Φ540–Φ630 mm |
| Nominal stamping force | 2500 KN × 2 |
| Work table height | 1000 mm |
| Air consumption | 0.26 m³/min |
| Compressed air pressure | 0.6 MPa |
| Total power | 73 kW |
| Footprint (L × W) | 23 m × 7 m |
| Power supply | AC 380 V / 50 Hz, 3-phase + N + PE (customized to destination) |
| Protection | Control cabinet IP54, actuators IP65 |
| Lead time | 60 – 90 days after contract effectiveness |
The more specific your information, the more accurate the quote. Ideally include: cylinder size (1 / 5 / 12.5 / 15 / 25 / 50 kg), sheet thickness, target daily output, existing process and available floor area.
